Apache OpenOffice (AOO) Bugzilla – Issue 22168
Graphic resize, relative, keep ratio not working
Last modified: 2004-09-16 12:48:32 UTC
Resizing graphics using the Graphics dialog, using relative values, and keeping the ratio is not working. That is, it is not keeping the ratio. It happens when enlarging or reducing graphics, and it only happens for me when relative values are used.
Please explain more about your problem, your information is not enough to investigate the problem. Please explain step by step. Thanks
reassigend to jw
Insert a graphic from a file. Open the Graphics dialog. On the Type tab, in the Size section, check the following boxes: Width - Relative, Height - Relative, and Keep ratio. Don't make any size changes yet; click OK. (It apparently only happens after the first time.) Open the Graphics dialog again. On the Type tab, in the Size section, click on either the up or down arrows in the width or height boxes. You should note that if you click on an arrow in the width box, the height value will change to either a very high or low incorrect percentage. Vice versa, if you click on an arrow in the height box, the width value will do the same. Also, unchecking one or both of the Relative boxes will yield similar results, even with the inch values. (You have to exit and reenter the Graphics dialog to see the last two, just as you did the first one.) The image I am testing with is a color TIFF with the dimensions 2.5x3".
i think this issue is a duplicate of i21284 set to duplicate *** This issue has been marked as a duplicate of 21284 ***
closing