Issue 41942

Summary: Bend connector X/Y control inverted
Product: Draw Reporter: lauwr <l>
Component: editingAssignee: AOO issues mailing list <issues>
Status: CONFIRMED --- QA Contact:
Severity: Trivial    
Priority: P5 (lowest) CC: issues
Version: OOo 2.0   
Target Milestone: AOO Later   
Hardware: PC   
OS: Windows XP   
Issue Type: DEFECT Latest Confirmation in: ---
Developer Difficulty: ---

Description lauwr 2005-02-03 06:03:53 UTC
Attach the "wrong" end of any of the bend connectors to the top or bottom of a
shape and the bend point responds to X coordinate movement, rather than Y.

When it's a single ended arrow, the wrong end is the arrowhead. Attach the tail,
and it works fine.

When attached to the sides of the shape, no problem again.

Also, the colouring of the points is inconsistent. They go red when you've
connected the "right" end, but stay blue for the wrong end. This side of the
misbehaviour applies to the other connectors as well, though their control
points work fine.

All the problems disappear as soon as the other end of the connector is attached
to something.

An example file is at <>.
Comment 1 lauwr 2005-02-03 06:27:01 UTC
I got an error back (after about a five minute delay) from OOo's server - I was
a bit to quick to resubmit the page, which became issue 41943, without checking
to see if this one had been recorded. One of them needs deleting. This one, I
Comment 2 wolframgarten 2005-02-03 08:15:25 UTC
*** Issue 41943 has been marked as a duplicate of this issue. ***
Comment 3 wolframgarten 2005-02-03 11:02:20 UTC
Target set.
Comment 4 wolframgarten 2005-02-22 11:53:38 UTC
Comment 5 wolframgarten 2005-02-22 11:54:20 UTC
Reassigned to Armin.
Comment 6 Armin Le Grand 2005-04-12 09:43:58 UTC
AW: Marked b4966500 as double to this one and closed it. I had to close it since
it does not accept a IssueZilla BugId as double Id.
Comment 7 Armin Le Grand 2008-07-02 15:27:08 UTC
Added note
Comment 8 Marcus 2017-05-20 11:31:45 UTC
Reset assigne to the default "".