Apache OpenOffice (AOO) Bugzilla – Issue 41942
Bend connector X/Y control inverted
Last modified: 2017-05-20 11:31:45 UTC
Attach the "wrong" end of any of the bend connectors to the top or bottom of a shape and the bend point responds to X coordinate movement, rather than Y. When it's a single ended arrow, the wrong end is the arrowhead. Attach the tail, and it works fine. Version 1.9.71.1 When attached to the sides of the shape, no problem again. Also, the colouring of the points is inconsistent. They go red when you've connected the "right" end, but stay blue for the wrong end. This side of the misbehaviour applies to the other connectors as well, though their control points work fine. All the problems disappear as soon as the other end of the connector is attached to something. An example file is at <http://www.l.dsl.pipex.com/OOo/BendBug.odg>.
I got an error back (after about a five minute delay) from OOo's server - I was a bit to quick to resubmit the page, which became issue 41943, without checking to see if this one had been recorded. One of them needs deleting. This one, I guess.
*** Issue 41943 has been marked as a duplicate of this issue. ***
Target set.
Reproducible.
Reassigned to Armin.
AW: Marked b4966500 as double to this one and closed it. I had to close it since it does not accept a IssueZilla BugId as double Id.
Added note
Reset assigne to the default "issues@openoffice.apache.org".